In this article I want to share to you on how to create and configure vlan on Linux through Cisco Catalyst Switch.
Requirements:
1. Linux installed on a PC with one or more NICs (Network Interface Card). I use Centos 5.4 using 2.6.18-164.11.1.el5PAE kernel. It should be applicable on other Linux distros such as Slackware, Ubuntu, Fedora, Debian, etc.
2. Cisco Catalyst Switch 2950
3. 2 PC/Laptop running Windows/Linux/BSD/MacOSX
4. 3 straight cables
This tutorial is based-on network diagram below:
continue reading…
Incoming search terms for this post:
- config linux to use trunk port (1)
- vconfig add inerface ifconfig without ip -wlan -rip -authentication -wireless -no cdp -bridge (1)
- linux vlan trunk (1)
- linux vlan no rx (1)
- linux show vlans (1)
- linux enable trunking vlan (1)
- installing 8021q redhat lsmod (1)
- good diagram cisco catalyst switches (1)
- fedora added VLAN with VID (1)
- debian vlan trunk (1)
- create and configure vlan in linux (1)
- vlan on linux and catalyst switch (1)
